- NOROX® 505-80 is a colorless, free-flowing liquid consisting primarily of approximately 80% w/w 1,1-di-tert-butylperoxycyclohexane.
- This product is a cyclic aliphatic peroxide used as an initiator for unsaturated polyester resins in the hot-press molding temperature range (130–150°C).
- Appearance: Colorless liquid.
- Peroxide Content: Approximately 80%.
- Active oxygen content: Approximately 9.82%.
- Desensitizer: Aliphatic hydrocarbons (boiling point > 170°C).
- Density (20°C): Approximately 0.89 g/cm³.
- Viscosity (20°C): approximately 4.81 mPa·s.
- Refractive index (20°C): approximately 1.434.
- Miscible with alcohols and phthalates, but insoluble in water.
- Explosion hazard temperature: approximately 85°C.
- Recommended storage temperature: below 30°C.
- Shelf life: 6 months.
- Used as a curing agent for unsaturated polyester resins.
- Temperature range: 120–160°C.
- Dosage: 0.5–2.5% of the total formulation.
- The “shelf life” at room temperature can vary from several weeks to several months depending on the resin type.
- Very low sensitivity to fillers, pigments, cobalt salts, or tertiary aromatic amines. Adding 0.1–0.3% Inhibitor BC 500 can significantly extend the shelf life.
- Within the 80–90°C range (“initiation temperature”), the curing rate is not very fast if the reaction heat does not cause a temperature rise (e.g., in an insulated mold).
- Only at temperatures above 120°C can a truly short curing time of 1–3 minutes be achieved.
- The optimal temperature range for hot-press molding is 130–150°C.
- The standard packaging for NOROX 505-80 is 20 kg.
- This information and all technical recommendations are based on internal testing of local raw materials and are intended to provide information about the product and its applications.
- This information does not constitute a warranty regarding the properties of the described product or its suitability for specific applications, nor does it provide instructions for use.
- This information does not guarantee the product’s characteristics or shelf life, nor does it assume any liability for third-party intellectual property rights, particularly patent rights.
- United Initiators reserves the right to make any changes based on technical progress or further developments.
- The applications and uses of the products in accordance with our technical recommendations are beyond our control and are the sole responsibility of the user.
- It is the user’s responsibility to carefully inspect and test the purchased products to verify their suitability for the intended application.